HP Tuners VCM Suite
This product was added to our catalog on Tuesday 16 September, 2008.
This is the awesome HP Tuners VCM Suite for the Solstice/Sky base and GXP/Redline.
This is the same software and interface we use to tune our MAX Power GXP to an insane 375whp on pump gas alone!
Parameters that can be changed with the HP Tuners VCM Suite are as follows -
1. Monitor sensors and many outputs from the ECU using the "Scanner". View data generated as the car runs via tables, charts and histograms. View in real time and record it.
2. Use the "Editor" to change many tables that the ECU uses to control the car, such as:
Airflow - tune "MAF Correction" to obtain near 0 short term fuel trims with aftermarket intake pipes.
Fuel Control - as you increase boost and airflow thru the engine, you'll want to obtain a constant and safer Air Fuel Ratio by modifying the "Power Enrich Table"
Change spark timing vs cam angles, RPM & AFR
Change cam lobe angles vs load and RPM
Recalibrate your speedometer for changes in tire sizes.
Read error codes, clear them, and even set the VCM to ignore them.
Increase boost thru air load tables
Raise rev limit.
Minimum computer requirements: Windows 98SE or Better
400 MHz PC or Laptop, 128 MB of RAM, USB Port.
***STANDARD INTERFACES ONLY AVAILABLE UNTIL NEXT GENERATION DEVICE BECOMES AVAILABLE 6/18***